Version 11.4
Updates and Service Packs
Available for
Windows/Unix/Linux
Last updated
January 19, 2007 at 03:30 PM CST
Note: The 11.4 CD
ROM does not contain installations for SCO UNIX 5.0.4, 5.0.5 and Linux
GLIBC 2.0 and 2.1 as they are no longer supported. Please click
here for a download and additional instructions.
IMPORTANT INFORMATION
Year-end 2007
If you are looking
for the Year-end 2007 update, if you have not already done so, install the
updates on this page first, then go
here.
Go to the bottom of the that page select the operating system you are
updating. Read the entire instructions before installing. There is also an
fix to the year-end update on the same page. Be sure to install that
as well.
Please read all of
this information before proceeding to the updates.
- General information
about installing updates
- It is recommended that you back up your software before installing
any updates.
- All users should exit out of the software when applying the updates.
- The updates do not check your version numbers. We recommend
that you check the version you are on before applying an update.
To view version numbers, start PBS and press F1 at the "User
ID" field.
- Downloading and installing an update will update your module's version
number to the version number indicated in the "Fix Version"
column. After installing an update, you can verify that the
update was applied properly by rechecking the version numbers.
- Every installation requires the System Manager update. Other
updates should be applied as needed based on the modules you have
installed.
- After installing an update, you may need to set file permissions
and ownership for the programs that were installed.
- If you have any custom programming or custom modules installed do
not install any updates until you have contacted your customization
dealer.
- If you are a source dealer and need the source code for any of these
updates, please contact support at support@pass-port.com
- Information for installing
updates for Windows
- The update may be in one of two formats, either a self-extracting
"exe" file, or a "zip" file.
- For a self-extracting "exe" update: Download the
update program, run it, and when prompted, point to the location of
where your software is installed.
- For a "zip" update: Download the zip file, place
it in the top level directory where the software is installed, and
unzip it using the "folders" option. The updated programs
will then be placed in their proper sub-directories.
- Information for installing
updates for Unix/Linux
- The updates for Unix/Linux are contained in tar files. Download
and place the tar file in the top level directory where your software
is installed. Then untar it using the command:
tar xvf tar_file_name.tar
|
